Backplate with folding stand and antenna mounts (Rama Shunn)
A printed rear plate that builds in a folding stand and positions for external antennas, published on Printables in February 2025.
What it takes
- 3D print
- Disassembly
Difficulty 2 of 3 — moderate.
Details
One of several printed backplates that trade the aluminium back for plastic to help Wi-Fi and add antenna positions; this one integrates a folding stand in place of the stock kickstand. Printables is the only source — no forum thread or fit reports were found — so check battery-door and screw-hole fit against your unit before committing filament.
Links
Open at Printables — Backplate with folding stand and antenna mountsRelated mods
A complex printed back cover on MakerWorld with a built-in prop stand and optional antenna mounts.
A slimmer plastic backplate that helps Wi-Fi by getting the aluminium out of the way and hides extra radio hardware, with a matching antenna side compartment.
The most-printed external antenna mounts for the uConsole — a small bracket on the console's own M4 screw positions with an RP-SMA bulkhead for a short whip.
A printed bracket that bolts to the console's flat-head M4 screw positions and carries three SMA antennas; a companion profile fits the HackerGadgets AIO board.
A single-piece remix of paragonnov's three-antenna bracket that prints as one part, so there is nothing to glue.
A tape-on printed hinge that holds the antenna flat for carrying and folds it up, clear of the metal body, when you need the signal.